cannot get calibre companion to connect to server

I can't type in, or navigate to the actual ebook library i set up in disk4. These paths seem to be all in the docker image still. I set the /books library path to /mnt/disk4/Ebooks/calibre_library/ then installed the Docker.īooted up Calibre in guac and have the prompt to 'choose a location' for my books. I deleted the appdata and downloaded linuxserver's calibre. Let me try this again, from the beginning. As stated before, when you run the wizard upon setup, make sure you have the /disk/books path set correctly. Searching and reading the threads would help in not cluttering the forums with the same question that has already been answered. If you would literally read the last page of this thread (this page), you would find the answer just as I did and wouldn't have to ask the same question. I came here with the exact same problem after noticing that my /books folder had no content and the database and books were written to the /appdata path. When doing conversions, it is filling the docker image and I am assuming it may be filling with temporary files. I have set the library in the docker settings to be on my share drive, but it still seems it's copying things to the docker. Definitely some temp data in there somewhere. Is there a folder somewhere I should go in and delete? Any help is greatly appreciated, thank you!Įdit: I cancelled the pending conversion jobs and increased my docker img size so I could restart the calibre docker and have some room to work. So now I'm sitting here with a full docker image and can't figure out how to clear whatever cache they're all sitting in. However I didn't realize that Calibre was going to copy all of those files into the docker image to accomplish this. I stupidly started a massive bulk book conversion job to make my library kindle friendly.

My apologies if this has already been asked, but a search didn't return any results.

Cannot get calibre companion to connect to server